How to get Plywood Cut to Size – Oak faced MDF

While cutting plywood cut to size you must have all the relevant information concerning plywood and method of cutting it to proper size without splintering in an effective and efficient manner. Plywood is made of a number of thin layers of the softwood or hardwood glued together at right angle. The placing of right angles gives increased strength to wood. Generally plywood sheets of standard size come in size of 4 by 8 feet. As the sheets are awkward and floppy it is difficult to cut them to needed size using table saw. Its bottom layer may chip along cutting line at the time of cross cutting the panel.

There are different ways of getting plywood cut to size easier, accurate and with minimum splintering. Splintering can be easily avoided by using saw especially made for cutting of plywood. The blades have about 80 teeth ground in such a way to create shearing and clean cut. The blade must be cleaned before cutting plywood if it has pitch crusted or sawdust on it.

First lay good side of plywood on stable surface and take correct measurement before you start cutting it. Put 2by 4 that is lengthier than the plywood sheet over sheet to ensure to line up an edge of2by4 in such a way to reinforce rectangular guide of saw against it. Clamp 2 by 4 to sheet with the table clamps that would permit 2 by 4 to be the cutting guide. You have to decide in the beginning itself whether you require more drawers, shelving or wardrobe space and could use oak faced mdf too. You could also build short hanging or long hanging exactly as per your need.

There is no harm in measuring twice before cutting as nothing can be done later if measurement is not proper. After measuring length and width, mark measurements with pencil on the sides. Make a line between these two points with a chalk for ensuring clear cut guide for the saw. You should now extend side of sheet few inches on edge of the work surface so that the table is not cut. Now reinforce rectangular guide of saw against it.

The correct way of preventing veneer is to score cutting line with saw blade. You will initially get a shallow cut with the saw. This will score line and forge the groove before final pass is made. With the help of the saw you now make second cut of full depth along the line, letting the extra plywood sheet fall on to the ground. Another method that you could use for preventing splintering or chipping of veneer from bottom is to make use of some backer board. This is a plywood piece that lets the veneer being supported and the plywood to be cut properly and cleanly.

Laminated or raw egger boards or Medium Density Fireboard having high layer density is utilized for making the furniture of superior quality and applying interior designs. This supports surface processing or individual edge profiling.

The Major Characteristics of Egger Boards are:

• High edge stability

• Suitable for profiling

• Very good surface quality

• High bending resistance

• Adequate static loading capacity

• Excellent good density profile

• Low swell values